Dimensioned drawings for Phase I of the kart. At this
point the kart was using the 5hp Briggs engine and a smaller seat. One
design criteria was that the kart fit in the back of my Toyota truck which was
4.5' x 6'. The kart fit but the cockpit ended up being pretty tight for me
at 5'6" so keep that in mind, you may want to grow the frame a little
bit.
These drawings are the only documentation I have from this
project, obviously not every detail of the kart is shown here but that's because
a lot of it was done on scratch paper out in the garage.
Have fun.
Side View
Top View
One side of front suspension
